Mounting Suggestions for Mustang Seats
FLT and FLHT 1983-96
One-Piece Ultra Touring

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.

_________________________________________________________________________________
A.
Baseplate Features

One-piece Ultra touring seats are constructed on extra rugged, triple layered fiberglass. The baseplate is slotted in the middle to allow for the use of a driver backrest.

NOTE: 1983-90 Mustang FL seats mount to stock Harley-Davidson® handrails. If the handrail is removed, this fender bracket is needed in its place on 1983-90 models. Part # 78007.


For general information about Mustang seat construction Click Here.
_________________________________________________________________________________
B.
Mounting of Mustang
Seat


1983-90 FLT/FLHT Ultra Touring
1. Remove nuts and washers from studs on baseplate of seat.
2. Engage nose of seat with bracket on frame.
3. Align rear studs with stock chrome seat rail or FL seat bracket (Mustang part #78007).
4. Fasten with supplied washers and nuts.

1991-96 FLT/FLHT Ultra Touring
1. Install supplied chrome triangle "Z" bracket and tighten screws.
2. Engage tab on frame of bike into receiver at nose of seat.
3. Firmly push seat forward to meet chrome dash panel.
4. Align slot in chrome triangle "Z" bracket with threaded hole on tourpack platform.
5. Secure with stock screw.



Enjoy the comfort of your new Mustang Seat.