Mounting Suggestions for Mustang Seats
FLT and FLHT 1983-96 Two-Piece

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.

_________________________________________________________________________________
A. Baseplate Features

Solo and rear seat baseplates are constructed of marine-grade fiberglass. Solo seats have two chrome mounting tabs that align with the stock threaded fender mounts. Rear seat mounts vary by model number.

For general information about Mustang seat construction Click Here.
_________________________________________________________________________________
B. Mounting of Mustang Seat

1983-96 FLT, FLHT Solo
Hardware included: two white washers

1. Engage tab on frame of bike into receiver at nose of seat.
2. Seat is spring loaded for a tight fit so the mounting tabs will be approximately 1"-1.5" above fender.
3. Align chrome rear tabs with threaded holes in fender.
4. Start one 5/16"-24 x 3/4" (1983-94), 5/16"-18x3/4 (1995-96) mounting bolt to finger tight and then do second, before securing both.

NOTE: If the fender holes have been filled in, use Harley-Davidson® 5/16" x 18 clip nuts or drill and tap out the old weld nuts.

1991-96 FLT, FLHT Rear Seat

14" Wide

Required mounting hardware: Mustang solo mounting bolts part #78027 1983-94, #78028 95-96

1. Rear of the Mustang solo is secured using Mustang solo mounting bolts part #78027 or #78028.
2. Engage front slots in passenger seat baseplate onto solo mounting bolts part #78027 or #78028.
3. Align rear tab with threaded hole in fender.
4. Secure rear tab with stock screw.

11" Wide

Required mounting hardware if handrail is removed:
Mustang part #78007 rear seat bracket.

1. Handrail or Mustang rear seat bracket part #78007 must be installed using bolts that mounts solo.
2. Fasten front of rear seat to handrail or mounting bracket using supplied 1/4-20" hex head bolts.
3. Align rear tab with threaded hole in fender.
4. Secure rear tab with stock screw.




Enjoy the comfort of your new Mustang Seat.

COPYRIGHT© 2007 MUSTANG MOTORCYCLE PRODUCTS, INC. ALL RIGHTS RESERVED
No part of this web site may be reproduced or transmitted in any form by any means without Prior Written Permission from Mustang Motorcycle Products, Inc.

Contact the Webmaster