Mounting Suggestions for Mustang Seats
Honda VT1100 ACE 1995-01, Two-Piece

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.


A.  Baseplate Features (Click on picture for a larger view)

The two-piece seat is built on a marine-grade fiberglass baseplate. Rubber bumpers are positioned to protect the frame and fender. Solos have two powder coated brackets that align with stock side mounts.

For general information about Mustang seat construction Click Here.

B.   Removal of Stock Seat (Click on picture for a larger view)

1. Remove rear fender acorn nut with 10mm wrench.
2. Remove the mounting bolt on each side of the solo seat with a 12mm socket.
3. Slide seat back and up.

C.   Mounting of Mustang Seat


Hardware included:
One nylon washer and two 1/4-20 x 3/4" screws.1. Bolt the solo and rear seat together using the supplied 1/4-20 x 3/4 screws.
2. Engage nose tab under frame below gas tank, not under gas tank flange.
3. Place nylon washer (supplied) between chrome triangle and fender.
4. Set rear fender screw loosely.
5. Install stock side bolts and tighten.
6.Tighten rear fender screw.

Enjoy the comfort of your new Mustang seat.

All text and graphics are COPYRIGHT © 2002 AL SIMMONS COMPANY, INC. ALL RIGHTS RESERVED
No part of this web site may be reproduced, or transmitted in any form by any means without PRIOR WRITTEN PERMISSION of Al Simmons Company.

Contact the Webmaster

Revised 9/02