Mounting Suggestions for Mustang Seats
Honda VT1100 Aero 1998-02

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.

A.  Baseplate Features (Click on picture for a larger view)

The two-piece, marine-grade fiberglass baseplate is a direct replacement for the stock two-piece seat. Rubber bumpers are positioned to protect the frame and fender.

For general information about Mustang seat construction Click Here.

B.   Removal of Stock Seat

1. Remove rear fender acorn nut with a 10mm wrench.
2. Remove the mounting bolt on each side of the solo seat with a 12mm socket.
3. Slide seat back and up to remove.

C.   Mounting of Mustang Seat (Click on picture for a larger view)


Hardware included:
One nylon washer

1. Check to make sure the two 1/4"-20x3/4" screws that secure rear seat to solo are tight.
2. Engage nose tab under frame, not under tank flange.
3. Supplied nylon washer goes between chrome mounting triangle and fender.
4. Secure seat using two stock side bolts and one rear fender mount.
5. Secure with stock acorn nut.
 

 

Enjoy the comfort of your new Mustang seat.

All text and graphics are COPYRIGHT © 2002 AL SIMMONS COMPANY, INC. ALL RIGHTS RESERVED
No part of this web site may be reproduced, or transmitted in any form by any means without PRIOR WRITTEN PERMISSION of Al Simmons Company.

Contact the Webmaster

Revised 9/02