Mounting
Suggestions for Mustang Seats
Honda VLX 600 1999-03
|
Mounting
Suggestions for Mustang Seats
|
|
Honda VLX 600 1999-03 |
|
All information is available at www.MustangSeats.com in color with larger images. |
||
| A. Baseplate Features |
 |
|
|
The one-piece, marine-grade fiberglass baseplate is a direct replacement for the stock baseplate. Rubber bumpers are positioned to prevent the seat from touching the frame and fender. |
||
|
B. Removal of Stock Seat |
||
 |
 |
|
|
1.
Remove 6mm mounting bolt on each side.
|
2.Slide seat back, then up to remove. | |
|
C. Mounting of Mustang Seat |
||
 |
 |
|
|
1. Slide tongue at seat nose
under formed |
2.
Make sure rear fork brackets slide under studs in fender. |
|
|
Continued
on next page
|
||
 |
 |
|
3. Push seat forward about 1/4". Install a bolt on one side leaving it a little loose, then go to the other side and install that bolt. 4. Tighten bolts evenly--a little on one side, then the other. (If one bolt is completely tightened first, it will cock the seat to one side, making the other bolt hard to install.) A 1/4" space between the side brackets and the frame is needed to put pressure on the nose bracket as the screws are tightened. Important: The seat centers itself to the gas tank, not the side covers. (The left side cover is 1/2" to 5/8" wider.) |
||
|
|
||
|
||
