A.  Baseplate Features (Click on picture for a larger view)

The two-piece, marine-grade fiberglass baseplate is a direct replacement for the stock two-piece seat. Rubber bumpers are positioned to protect the frame and fender.

For general information about Mustang seat construction Click Here.

B.   Removal of Stock Seat

 

1. Remove rear 6mm fender
screw and 8mm screw on each
side of passenger seat.

2. Lift passenger seat and hand strap off bike.

 

3. Remove the two 8mm solo bolts.

4. Lift rear of solo up then slide back to remove.

5. Remove the two 8mm screws holding passenger seat mounting bracket to fender.
Remove bracket, this will not be used with the Mustang seats.

6. Reinstall 8mm screws.

C.   Mounting of Mustang Seat

1. Slide solo nose bracket into receiver under tank. Make sure bracket goes into receiver and not on top.

2. Push solo forward until side brackets line up with frame mounts. Secure solo with stock 8mm bolts.

3. Slide tongue on front of passenger seat into receiver on solo.

 

4. Push passenger seat forward to align rear mounting bracket with fender hole.
Secure with stock 6mm screw.