Mounting Suggestions for Mustang Seats

Honda VTX 1800 Retro One-Piece Seat

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Monday - Friday, 9:00 to 5:30, Eastern time.
Click for printer friendly version

A. Baseplate Features

The one-piece, marine grade fiberglass baseplate is a direct replacement for the stock two-piece seat. Rubber bumpers are positioned to protect the frame and fender.

B. Removal of Stock Seat



1. Remove one 8mm Allen bolt on each side of the front of the passenger seat.
2. Remove 8mm Allen bolt at back of passenger seat. Lift seat up to remove.

 

3. Remove one 8mm Allen bolt on each side of solo. Lift back of solo up and slide back to remove.

4. Unbolt U-bracket from center of fender. (This will not be needed for mounting the Mustang seat.)

C.Mounting of Mustang Seat


Hardware included: one nylon washer

1. Slide nose bracket into frame under gas tank.

2. Secure rear of seat to fender with stock 8mm bolt, placing nylon washer between tab and fender to protect paint.

 


Enjoy the comfort of your new Mustang seat.

All text and graphics are COPYRIGHT © 2003 AL SIMMONS COMPANY, INC. ALL RIGHTS RESERVED
No part of this web site may be reproduced, or transmitted in any form by any means without PRIOR WRITTEN PERMISSION of Al Simmons Company.

Contact the Webmaster