Mounting Suggestions for Mustang Seats
Honda VTX 1800-C

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.

_________________________________________________________________________________
A. Baseplate Features


The two-piece, marine-grade fiberglass baseplate is a direct replacement for the stock two-piece seat. Rubber bumpers are positioned to protect the frame and fender.

For general information about Mustang seat construction Click Here.

_________________________________________________________________________________
B. Removal of Stock Seat



1. Remove the Allen bolt on each side of solo with a 6mm Allen wrench.
2. Remove the acorn nut at the rear of the seat with a 10mm wrench.
3. Lift seat up and back to remove. (Front and rear seat are bolted together.)
_________________________________________________________________________________
C. Mounting of Mustang Seat

Hardware included:

One chrome spool washer
One 1" x 6mm bolt
Two nylon washers

1. Install one nylon washer under chrome spool washer and then secure to fender with 1" x 6mm bolt.

2. Mustang solo mounts just like stock: Slide
nose bracket into frame under gas tank.
3. Secure to frame using stock Allen bolts through side brackets.

4. Slide the passenger seat into spool washer under solo.
5. Use one nylon washer between rear chrome bracket and fender.
6. Secure using stock 6mm acorn nut.
_________________________________________________________________________________

Enjoy the comfort of your new Mustang Seat.