Please review the
information below. If you have any questions or need further technical
assistance, you are welcome to contact one of our Mustang seat experts
by clicking here or call 800-243-1392 or 860-582-9633 Monday - Friday, 9:00 to 5:30, Eastern
time.
|
 Click
for printer friendly version |
A.
Baseplate
Features
|
One-Piece Touring Seats
are constructed on a marine-grade fiberglass baseplate. The baseplate
is slotted in the middle to allow for the use of a Mustang or stock
Harley-Davidson® driver backrest kit.
For general information
about Mustang seat construction Click
Here.
|
 |
B. Removal
of Stock Seat
|
1. Remove rear fender screw.
2. Slide passenger seat back and up.
3. Remove solo mounting bolts located at back of
solo, 5/16"-24 thread on
1994 models or 5/16-18" thread on 1995-96 models.
4. Slide solo seat back and up.
|
C. Mounting of Mustang Seat
|
Hardware included: Special fender bracket
1. Unbolt special fender bracket from underside of Mustang seat.
2. Secure special bracket to fender using stock solo bolts.
3. Engage front nose clip into tab on frame.
4. Lower rear of seat down to fender aligning two studs on bottom of
seat into special fender bracket.
5. Secure chrome rear fender bracket to fender with stock screw.
6. Fasten special fender bracket to seat with supplied washers and
nuts.
|
Enjoy the
comfort of your new Mustang seat.
|
|
All
text and graphics are COPYRIGHT © AL SIMMONS COMPANY, INC.
ALL RIGHTS RESERVED
No part of this web site may be reproduced, or transmitted in any form by
any means without PRIOR WRITTEN PERMISSION of Al Simmons Company, Inc.
Contact the Webmaster
