| Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time. |
|
A. Baseplate
Features
|
|
For general information
about Mustang seat construction Click
Here.
The solo features a 16 gauge
formed steel baseplate with rubber bumpers to minimize vibration
and prevent it from touching the frame. This is a direct replacement
for the stock solo. Two chrome
mounting tabs align with the fender inserts/studs.
|
|
B. Removal
of Stock Seat
|
Two-Piece Seat
1. Remove rear fender screw.
2. Slide passenger seat back and up.
3. Remove solo mounting bolts located at the back of the solo.
4. Slide solo seat back and up.
|
Solo Seat
1. Remove solo
mounting bolts.
2. Slide solo seat back and up.
One-Piece Seat
1. Remove rear fender
screw.
2. Remove hand strap that is secured to bike on each side where
front saddle bag mount is located.
3. Slide stock seat back and up.
|
|
C. Mounting
of Mustang Solo Seat
|
|
Hardware included:
Two white flat nylon washers.
|
1. Engage nose of seat,
pushing seat as far forward as possible so that the mounting holes
in the fender are in the middle to back edge
of the slotted tabs.
2. A firm downward chop to the nose of the seat will push the seat
closer to the chrome dash.
3. Seat is spring loaded for a tight fit so the mounting tabs will
be approximately 1"-1.5" above the fender.
4. The supplied nylon washers go between the mounting tabs and the
fender.
5. Start one mounting bolt to finger tight and then do second,
secure both.
|
|
|
|
|
Enjoy the
comfort of your new Mustang seat.
|
|
