Hardware
included:
1999-up - two black nylon shoulder washers
1997-98 - two black flat nylon washers
Black tie wraps
1.Engage nose of seat,
pushing seat as far forward as possible so that the mounting holes/studs
in the fender are in the middle to back edge of the slotted tabs.
2. A firm downward chop to the nose of the seat will push the seat closer to
the chrome dash.
3. Seat is spring loaded for a tight fit so the mounting tabs will be approximately
1"-1.5" above the fender.
4. The supplied nylon washers go between the mounting tabs and the fender.
5. Start one mounting bolt/nut
to finger tight and then do second, secure both.
6. 1997-98 models require that the black retention clip must be left in place
to hold the nut insert in fender. 1997-98 models require seat mounting bolts
(Mustang part #78028) or stock H-D.
7. On 1999-up models the studs in the fender have some movement to help with
lining up the tabs.
1999-up models require Road King seat mounting nuts (Mustang part #78032 or stock
H-D). (FIG. 1)
FIG. 1
 * If there
is a gap between the nose of the driver seat and the dash, be sure
seat is as far forward as possible and adjust the chrome dash.
Dash is adjusted by loosening the 1/2" hex nut and phillips
screw on dash. Slide dash back and retighten. On 2004 models nose
bracket on solos can be opened up approximately 1/4" for best
fit.
*All
wiring harnesses must be positioned on the inside of the frame
rails. If necessary cut the factory tie wraps and roll harness
inside the rail and retie with supplied black tie wraps.
|
