 |
Mounting Suggestions for Mustang Tank Bibs |
||||||||||||||
| Please review the information below. If you have any questions or need further technical assistant, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Monday - Friday 9:00-5:30 Eastern time. |  |
||||||||||||||
 |
|||||||||||||||
Removal of Stock Panel |
|||||||||||||||
 |
|||||||||||||||
 |
|||||||||||||||
Remove Seat. With a 1/2" wrench, loosen the dash acorn nut and remove the lower panel screw. |
Lift back of dash approximately 1/2", then slide panel down off of the two mounting taps and out from under dash. | ||||||||||||||
Installation of Mustang Bib |
|||||||||||||||
 |
 |
 |
|||||||||||||
| Lift end of dash up and slide bib under until the top 2 chrome studs are covered. Covering the top studs ensures that it will not slide out. Now tighten dash nut. | Wrap the bib's velcro ties around frame at base of tank. | Lower mounting screw is not needed but can be installed if desired. | |||||||||||||
|
|||||||||||||||
Enjoy the look of your new Mustang tank bib. |
|||||||||||||||
|
COPYRIGHT© 2007 MUSTANG MOTORCYCLE PRODUCTS, INC. ALL RIGHTS RESERVED |
|||||||||||||||
