Mounting Suggestions for Mustang Seats
Sportster 2004-up Solo & Passenger Seat

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.

A. Baseplate Features


The two-piece marine grade fiberglass baseplate mounts using the stock rear fender screw. Vibration is minimized with the strategic placement of rubber bumpers.

For general information about Mustang seat construction Click Here.

B. Removal of Stock Seat

1. Remove the rear 1/4-20 fender screw with a Phillips screwdriver.

2. Lift back of seat up about 1" then push seat backward until the slotted center of the seat releases from the frame's shoulder bolt.

C. Mounting of Mustang Seat

1. Engage seat's nose bracket into the frame at the base of tank just like the stock seat.

 

 

2. Fasten back of solo to second hole in fender with supplied fender nut kit. Place solo seat's bracket over fender nut then fasten with our 1x1/4-20 Allen bolt and spool washer.
3. Slide rear seat into slotted spool washer then fasten to fender with the factory 1/4-20 screw.

Enjoy the comfort of your new Mustang seat.

 

COPYRIGHT© 2007 MUSTANG MOTORCYCLE PRODUCTS, INC. ALL RIGHTS RESERVED
No part of this web site may be reproduced or transmitted in any form by any means without Prior Written Permission from Mustang Motorcycle Products, Inc.

Contact the Webmaster