Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Monday - Friday, 9:00 to 5:30, Eastern time.

Click for printer friendly version

A.  Baseplate Features (Click on picture for a larger view)

The one-piece, marine-grade fiberglass baseplate is a direct replacement for the stock two-piece seat. The clip for the electronics module is built directly into the Mustang seat. Rubber bumpers are positioned to protect the frame and fender.

For general information about Mustang seat construction Click Here.

B.   Removal of Stock Seat

1. Remove both side covers.
2. Remove the two 5mm Allen bolts at front of the solo.
3. Lift solo up and forward.
4. Remove the two 10mm bolts holding the solo bracket and passenger seat to the fender.
5. The electronics module is attached to the passenger seat. Carefully slide passenger seat forward and up off bike.
6. Carefully remove electronics module from passenger seat.

Note: Put the solo bracket bolts back into the fender with wires on the outside of the bolts.

C.   Mounting of Mustang Seat

1. Clip electronics module to baseplate of seat.
2. Engage rear bracket on seat into receiver on fender.
3. Install two stock 5mm Allen bolts on each side of seat.
4. Install side covers.