Mounting Suggestions for Mustang Seats
Suzuki 700/750/800 Intruder 1985-up
All information is available at www.MustangSeats.com in color with larger images.

A.  Baseplate Features

The one-piece, marine-grade fiberglass baseplate is a direct replacement for the stock two-piece seat. The clip for the electronics module is built directly into the Mustang seat. Rubber bumpers are positioned to protect the frame and fender.

B.   Removal of Stock Seat

1. Remove both side covers.
2. Remove the two 5mm Allen bolts at front of the solo.
3. Lift solo up and forward.
4. Remove the two 10mm bolts holding the solo bracket and passenger seat to the fender.
5. The electronics module is attached to the passenger seat. Carefully slide passenger seat forward and up off bike.
6. Carefully remove electronics module from passenger seat.

Note: Put the solo bracket bolts back into the fender with wires on the outside of the bolts.

C.   Mounting of Mustang Seat

1. Clip electronics module to baseplate of seat.
2. Engage rear bracket on seat into receiver on fender.
3. Install two stock 5mm Allen bolts on each side of seat.
4. Install side covers.

 
If you have any questions, contact one of our seat experts at questions@MustangSeats.com or 800-243-1392 or 860-582-9633 Monday-Friday, 9:00 to 5:30, Eastern time. Enjoy the comfort of your new Mustang seat.