Yamaha Road Star 1600/1700
One-Piece Seats
Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts at questions@MustangSeats.com
or
call us at 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.
.
Baseplate Features
The one-piece, marine-grade fiberglass baseplate is a direct replacement for the stock, two-piece seat. Rubber bumpers are positioned to prevent the seat from touching the frame and fender.
For general information about Mustang seat construction Click Here.
Step #1
Open seat latch by turning ignition key counter-clockwise.
Remove stock seat
Step #2
Remove mounting bracket by removing the three 6mm bolts with a 10mm socket.
Re-install 6mm bolts.
Step #3
Remove 8mm mounting bolt with a 10mm socket
Step #4
Set seat on frame, aligning the rear bracket with the mounting hole in the fender.
Slide the supplied white nylon washer under the bracket and then install the stock 8mm bolt.
DO NOT TIGHTEN YET!
Step #5
Align the seat's nose bracket with the frames latch.
Push the seat's nose down to lock.
Now tighten the stock 8mm bolt with a 10mm wrench.
Turn the ignition key counter-clockwise to unlock the seat so it can be moved to the left to check the engine oil level.
COPYRIGHT© 2007 MUSTANG MOTORCYCLE PRODUCTS, INC. ALL RIGHTS RESERVED
No part of this web site may be reproduced or transmitted in any form by any means without Prior Written Permission from Mustang Motorcycle Products, Inc.
Contact the Webmaster