Mounting Suggestions for Mustang Seats
Royal Star Tour Deluxe 1300 2005

Please review the information below. If you have any questions or need further technical assistance, you are welcome to contact one of our Mustang seat experts by clicking here or call 800-243-1392 or 860-582-9633 Mon-Fri, 9:00 to 5:30, Eastern time.

_________________________________________________________________________________
A.
Baseplate Features


The two-piece marine-grade fiberglass baseplate directly replaces the stock two-piece seat. The solo utilizes the stock locking mechanism for easy removal. The rear seat engages into the stock bracket and bolts in the rear. Rubber bumpers are positioned to minimize vibration and prevent the seat from touching the frame and fender.



For general information about Mustang seat construction Click Here.
_________________________________________________________________________________
B.
Removal
of Stock Seat


1. Remove solo seat first.
Use a 5mm Allen wrench to remove the two front 8mm solo mounting bolts.

 

 

 

2. Lift nose of seat up and then forward to disengage it from frame.

 

 

 

3. Use a 10mm wrench to remove the 8mm hex head mounting bolt from the rear fender. Slide rear seat forward to disengage it from fender bracket and lift off.

_________________________________________________________________________________
C. Mounting of Mustang Seat


NOTE: Passenger seat is mounted first.

1. Center passenger seat on fender then slide it back to engage brackets on front passenger seat under bike's fender bracket.

 

2. Line up rear triangle bracket with hole in fender then install stock 8mm bolt. Tighten with a 10mm wrench.

 

3. Angle solo back and engage seat's bracket into bike's receiver. Bring nose of solo down and align seat's side brackets with holes in frame. Install two stock 8mm Allen bolts then tighten with a 5mm Allen wrench.


Enjoy the comfort of your new Mustang Seat.