Please review the
information below. If you have any questions or need further technical
assistance, you are welcome to contact one of our Mustang seat
experts by clicking here or call 800-243-1392 or 860-582-9633 Monday - Friday, 9:00 to 5:30, Eastern
time.
|
 Click
for printer friendly version |
A. Baseplate Features
(Click
on picture for a larger view)
|
The one-piece, marine-grade
fiberglass baseplate is a direct replacement for the stock, two-piece
seat. Rubber bumpers are positioned to prevent the seat from touching
the frame and fender.
For general information
about Mustang seat construction Click
Here.
|
 |
B. Removal
of Stock Seat
(Click
on picture for a larger view)
|
1. Custom: Remove rear fender acorn nut.
Classic / Silverado: Remove rear fender screw.
2. Lift rear of seat up and pull back to remove.
3. Remove two 6mm Allen bolts at rear of solo. Rear seat mounting bracket
will also be removed by these two bolts.*
4. Lift rear of solo up and pull back.
5. Reinstall the two 6mm Allen bolts into fender.
*NOTE:
Center bracket must be removed when installing Mustang seat.
|
|
|
|
|
C.Mounting of Mustang Seat
|
Hardware included: Chrome mounting bracket.
Custom: Install
supplied chrome bracket into forward set of mounting holes labeled
"Custom".
Classic/Silverado:
1. Install supplied chrome bracket into rear set of mounting
holes labeled "Classic" on the baseplate.
2. Slide nose bracket into the receiver at the base of the gas
tank.
3. Custom: Line up slotted chrome bracket with rear fender hole
and reinstall the factory bolt.
Classic / Silverado: Line up slotted chrome bracket with rear fender
hole and reinstall stock screw.
|
|
|
|
Enjoy
the comfort of your new Mustang seat.
|
|
All
text and graphics are COPYRIGHT © AL SIMMONS COMPANY, INC. ALL
RIGHTS RESERVED
No part of this web site may be reproduced, or transmitted in any form by
any means without PRIOR WRITTEN PERMISSION of Al Simmons Company, Inc.
Contact the Webmaster
